An essential requirement of industrial touchpanels is the EMC compliance
An essential requirement of industrial touchpanels is the EMC compliance. Other electrical equipment in the near vicinity should not disturb the operation of your product and it should also not disturb other equipment.
To obtain an EMC stable input system two main sources of interference have to be considered. The first source of interference are the displays which have to be integrated behind the touch panel and the power supplies being clocked. The EMC standard IEC 61000-4-3 refers to these interference sources.
Furthermore, the EMC standard IEC 61000-4-6 defines Conducted Coupling of interfering voltage peaks and frequencies. To eliminate these interference signals that the HMI system operates with positional accuracy without deviation of the touch function. This in turn does not cause false alarms and is a prerequisite for achieving EMC compliance to Class A.
With optimized AD converters in the evaluation electronics of the PCAP controller, increased signal voltages through charge pumps, special algorithms (frequency-hopping method and hardware/software filters) and interference sources can be suppressed comprehensively. With a sensor design specially adapted to the electronics, additionally an optimum signal-to-noise difference is achieved.
The following EMC standards have been met successfully:
IEC 60601-1-2: Edition 4.0
IEC 61000-4-3: Level III, 10 V / m, up to 28V / m @ 385 ~ 6000MHz
IEC 61000-4-4: Test Electrical Fast Transient / Burst Immunity. Level III, Vpp ± 2 KV
IEC 61000-4-6: Conducted Radio Frequency Immunity, Level III, 10V / m
SCHURTER has its own competence center with testing equipment for assessing conductive immunity. While testing during the development phase, possible EMC issues can be recovered. That gives more confidence in succeeding on the final (expensive) EMC tests the first time and this of course is cost-effective.
If you would like more information about what SCHURTER can do for you regarding EMC, contact us.